| Commit message (Collapse) | Author | Age | Files | Lines |
|
|
|
|
|
|
| |
* Update MACHINE_FEATURES for each machine to reflect the correct
features provided on a per machine basis
Signed-off-by: Nathan Rossi <nathan.rossi@xilinx.com>
|
|
|
|
|
|
|
| |
* U-Boot SPL is not supported for all Zynq boards unless the platform
init code is provided, so only enable it on a per machine basis
Signed-off-by: Nathan Rossi <nathan.rossi@xilinx.com>
|
|
|
|
| |
Signed-off-by: Nathan Rossi <nathan.rossi@xilinx.com>
|
|
|
|
|
|
| |
* Remove the use of MACHINE_KCONFIG, replace with KERNEL_FEATURES
Signed-off-by: Nathan Rossi <nathan.rossi@xilinx.com>
|
|
|
|
|
|
|
|
| |
* These changes have been merged into the base dtsi for zynq
* Clean up and remove non-required *-yocto.dts
* Update machine confs
Signed-off-by: Nathan Rossi <nathan.rossi@xilinx.com>
|
|
|
|
|
|
| |
* Currently configures virtual/bootloader to be part of the image
Signed-off-by: Nathan Rossi <nathan.rossi@xilinx.com>
|
|
|
|
|
|
|
|
| |
* Fix inclusion of zynq-7-mainline-gem.dtsi so that nodes properties in
the board level are not overwritten
* Add the *-yocto.dts to the machine configurations
Signed-off-by: Nathan Rossi <nathan.rossi@xilinx.com>
|
|
|
|
|
|
|
| |
* Move to linux/<arch> sub directories
* Update machine and kernel paths
Signed-off-by: Nathan Rossi <nathan.rossi@xilinx.com>
|
|
|
|
|
|
| |
* Cleaned up device trees, refactored the dts per boot args setup
Signed-off-by: Nathan Rossi <nathan.rossi@xilinx.com>
|
|
Add zc706-zynq7 machine dts files.
Signed-off-by: Sipke Vriend <sipke.vriend@xilinx.com>
|